includes 4 self-sealing female fittings

FEATURES:

4m gas hose kit. 1/2' in stainless steel with 4 self-sealing female fittings UNI EN 15266. Uniroll 1/2' complete kit for gas with yellow CSST coating UNI EN 15266 max 0.5bar. PLT-CSST corrugated pipe system in 316L stainless steel covered with a yellow protective coating for gas transport according to UNI EN 15266:2007 - UNI/TS 11340 regulations.

The "piping system (kit)" The coated PLT-CSST (corrugated stainless steel pipe) uniroll is certified and compliant with the European regulation UNI EN 15266:2007 in all its components, not requiring any intervention from the installer for the formation of the sealing elements (flaring), as required by point 3.2 of the reference legislation. It is also compliant with the technical specification UNI/TS 11340 relating to the installation of CSST piping where point 4.3.4 requires that the seal be guaranteed metal to metal. The covered CSST pipes are suitable for the construction of installations for domestic and similar use, for users with a single nominal heat input not exceeding 35 kW who use gases of the first family (town gas), second family (natural gas: methane) and third family (LPG). In the "bare" version, the pipes are suitable for the transport of drinking water, in compliance with decree no. 174 of 04/06/2004.

ASSEMBLY INSTRUCTIONS VALID FOR COVERED AND BARE HOSES:

Cut to the desired length and remove about 2.5cm of protective sheath from both sides, if any.
Insert the appropriate nut and position the preformed handle on the second wave of the corrugated tube. Bring the nut into contact with the preformed handle, insert the appropriate metal gasket.
Connect to the system or to a nipple with a flat stop and tighten so that the flared deformation of the corrugated tube seals between the two rings.
Use the special adhesive tape supplied, resistant up to 105°C, to seal the metal parts. To avoid corrosion and damage, form a double layer of it.

CERTIFICATIONS:

The Uniroll covered piping system is certified and compliant with UNI EN 15266:2007 which establishes all the necessary requirements for certification: design, materials, controls, manufacturing, marking. It is important to emphasize that "the entire system" complies with the aforementioned reference legislation, in particular point 3.2 where it is expressly specified: "foldable pipes and their associated components obtained or specified from a manufacturer who has the responsibility for the design and performance for the kit", performance which must therefore be guaranteed without the operator intervening manually in the formation of the sealing elements, which is why uniroll is "self-foldable". The UNI EN 15266 regulation also requires the manufacturer to constantly monitor the entire production process, in order to guarantee consistent product quality, it is also certified with the iso:9001 quality system.

Product Code: 11208